Shellcoding (Module 4)

pwn.college

Published on 2021-09-06

Note: Most of the below information is summarized from Dr. Yan Shoshitaishvili’s pwn.college lectures from the “Shellcode Injection” module. Much credit goes to Yan’s expertise! Please check out the pwn.college resources and challenges in the sources

This module relies heavily on preexisting x86 knowledge, so if you don’t have experience with x86 then I’d recommend taking a look at the last post and learning some of the basics or the rest of this post won’t make much sense. I would HIGHLY recommend also watching the lecture videos as you are able to see actual examples of what is explained here.

What is Shellcode

Most computer architectures treat code and data interchangeably, allowing us to manipulate data as code
- We can use shellcode to abuse this
The “traditional” goal with shellcode is to launch a shell (execve("/bin/sh", NULL, NULL))
- want to achieve arbitrary command execution
- not always to launch a shell (read a file we don’t have permissions for)
We can add data into out shellcode
- use .byte or .string

To write shellcode, need this format:

.global _start
_start:
.intel_syntax noprefix
    your shellcode

This will set up a global symbol to indicate the start of the shellcode (.global _start)
- This allows us to execute our code as a normal ELF file
Indicate where the start is (_start:)
Indicate that we are using Intel x86 instead of AT&T x86

Then we need to assemble it:

gcc -nostdlib -static shellcode.s -o shellcode-elf
- nostdlib: indicate we don’t want to use the standard libraries since we are instead calling them directly using systemcalls in the code
- -static: indicate we are only loading our code and are not dependant upon anything else
- -o shellcode-elf: output the compiled code into a file called “shellcode-elf”

The previous command will only create a program, not shellcode. To get the shellcode we need to do:

objcopy --dump-section .text=shellcode-raw shellcode-elf
- In our ELF file, there is a .text section that contains our shellcode. By running this command, we are dumping the .text section of the code into a new file we call “shellcode-elf”

Debuging:

After compiling your code with the instructions above, you can debug your code by running strace ./shellcode-elf
- This will display everything being executed by your code, which will often assist in finding any unwanted activity
gdb is a Linux command that allows you to walk through your code as it runs gdb ./shellcode-elf
- Caveats:
  - there is no source code to display and navigate.
  - to print the next 5 instructions: x/5i $rip
  - you can examine qwords (x/gx $rsp), dwords (x/2dx $rsp), halfwords (x/4hx $rsp), and bytes (x/8b $rsp)
  - to step one instruction (follow call instructions): si, NOT s
  - to step one instruction (step over call instructions): ni, NOT n
  - to break at an address/label: break *0x400000 or break labelName
  - run, continue, and reverse execution work as expected
- You can hardcode breakpoints
  - breakpoints are implemented with the int3 instruction
  - you can place this anywhere yourself!
  - especially useful at the start of shellcode to catch the beginning of shellcode execution

Common Challenges

Sometimes shellcode will not be allowed to use certain bytes as a result of how the program processes it like:
We can get around some of these restrictions by being creative:
Remember that data and code are interchangeable from the computers point of view, so we can data to our code as bytes that is called by other commands
- when doing this, make sure to have .text writeable by running gcc -Wl, -N --static -nostdlib shellcode.s -o shellcode-elf

What is Shellcode

Common Challenges

Sources